Mounting And Connections - Cobra 75 WX ST How To Use Manual

75 WX ST Manual(5188) 2/5/01 3:00 PM
Installation
Mounting and

Mounting and Connections

Connections
The Ju n ction Box is held by two scre ws, pe rm i t t i n g
mounting in the manner most convenient for
your installation.
Mounting hardware is supplied for mounting the
Junction Box. The mounting must be mechanically
s t rong and also provide a good elect ri cal co n n e ct i o n
to the chassis of the vehicle. Proceed as follows to
mount junction box:
After you have dete rmined the most co nve n i e nt
1
location in your vehicle, hold the Cobra HH-75
WX ST Junction Box in the exact location
desired. If nothing will interfere with mounting
it in the desired position,use the Junction Box
as a template to mark the location for the
mounting screws. Before drilling the holes,
make sure nothing will interfere with the
installation of the mounting screws.
Connect the antenna cable connector to
2
the antenna receptacle on the unit. Most CB
antennas are terminated with a type PL-259
plug and mate with the receptacle.
4
Page 4
For co n s t a nt 12 volt source powe r, co n n e ct
3
the red wire marked " BATT ( + ) "d i re ctly to the
po s i t i ve side of the bat te ry or to a co n n e ction
on the fuse block that is always on.
4 Co n n e ct the black wire marked "Gro u n d" to the
n e g at i ve side of the ca r, usually the chassis. Any
other location with good elect ri cal co nt a ct paint
re m oved will also wo rk .
Re m ove ru b ber grommet from metal
5
m o u nting plate (1).
Installation
Mounting and
Connections
Caution
Leaving the 75 WX ST on after
your car is turned off can drain
your car batte ry when co n n e cte d
to a constant 12 volt source.
When co n n e cted to an acce s s o ry
12 volt source the unit will turn
off when vehicle is turned off.
5