All Channel Scan; Channel Saver Feature - Cobra 75 ST EU Operating Instructions Manual

Operation
1 Set Squelch Control (SQL) to desired setting DSS. See
All Channel
page 14 to set DSS.
Scan
Note
The 75 ST EU will stop scanning
and monitor a channel when it
receives an incoming transmission.
Five seconds after the
transmission stops, the 75 ST EU
resumes the scanning function.
2 Press Scan key. Unit will start scanning.
3 When activity is found on a channel, scanning will stop.
Scan icon will appear
4 Press any key to stop scanning sequence.
22
PRESS
ANY KEY

Channel Saver Feature

Automatically retains the last channel used when CB is
turned off and returns you to that channel when CB is turned
back on. This feature works only when connected to a
constant 12 volt source.
Saving Channels in Memory
1 Select desired channel to store in memory.
RX
S 1 3 5 7 9 +30
FM
2 PRESS and RELEASE the Memory key.
TX 1 2 3 4 PWR
PRESS &
RELEASE
3 PRESS and HOLD the desired Memory Location key to
lock channel into memory.
PRESS &
HOLD
4 The Memory location will appear on the display.
S 1 3 5 7 9 +30
FM M
TX 1 2 3 4 PWR
Operation
Channel Saver
Feature
RX
23