Turning On Your Cb; Selecting A Channel (Country Of Use) - Cobra 75 ST EU Operating Instructions Manual

Installation
Installation
Operation
Turning Your Turning On
CB On
1 Rotate the power On/Off/Volume
Control clockwise.
2 Turn the Squelch Control
counterclockwise until
noise is heard.
3 Adjust volume to a
comfortable level.
Selecting a Channel
Selecting a
1 Change channels by pressing
Channel
either the channel p up button
or channel q down button .
Note
Sound clarity is measured by the
2 To quick-advance channels,
ratio of the signal level to the noise
press and hold either button.
level. The higher the signal-to-
noise ratio, the better the sound.
10
Installation
Installation
Before using this transceiver, please check that the radio has been programmed on the
frequency band specifications and operating modes allowed by the regulations valid in the
country where the product is used. If not, please proceed to modify the frequency band
programming, as described below. This transceiver is programmed at the factory on the
EU1 frequency band (40 CH AM 4W/40 CH FM 4W).
To Program Radio to Country of Usage
1 Press and hold the ST (SoundTracker
2 Turn power on to the radio. Release the SoundTracker
button. The band ID will flash on default ID "EU" (first
use only).
3 Press and release the Channel UP button for you ID
selection.
4 ID sequence: EU1aEUaCEa Gb aPLa E1 aI2a DEa
dE1a EU.
5 Press and release the SoundTracker
exit. The 75 ST EU will remember this setting after power
is turned off.
CB Antenna
Only a properly matched Antenna system will allow maximum
power output. In mobile installations (cars, trucks, boats, etc.), an
Antenna system that is non-directional should be used. When
installed in a boat, the transceiver will not operate at maximum
efficiency without a ground plate unless the vessel has a steel hull.
Before installing the transceiver in a boat, consult your dealer for
information regarding an adequate grounding system.
11
Operation
NOTICE!
) button.
®
button again to set and
®
11
®