Main Icons; Intro; Secondary Icons; Installation - Cobra 19 DX IV EU Owner's Manual

Main Icons

Included in this Package

Introduction

Intro

Operation
Included in this Package

Installation

CB Transceiver

Secondary Icons

Notice
Transceiver Bracket
Operating Manual
English
2

19DXIVEU_MANL_ENG_vL.indd 2-3

Customer Warranty
Assistance
•
Customer
Assistance
Microphone
Caution Warning
Microphone Bracket
Main Icons
Intro Operation
Installation and Start-Up Introduction
Installation
Intro Operation

Mounting and Connections

Secondary Icons
Select a location for the transceiver and microphone bracket that is con ve nient for
s n o I c n a i M
operation. In automobiles, the radio is usually mounted to the underneath of the dash
panel, with the microphone bracket beside it.
Installation
Notice
Transceiver Bracket
Secondary Icons
y n t r a a r W e r m o s t u C n i o a t e r p O o t r I n
e c n a i s t s s A
s n o I c n a i M
e r m o s t u C
n i o a t a l l s t I n
e c n a i s t s s A
Antenna Connector
s n o I c y a r d n o c e S
y n t r a a r W e r m o s t u C n i o a t e r p O o t r I n
e c n a i s t s s A
g n n i a r W n i o u t a C e i c o t N
e r m o s t u C
n i o a t a l l s t I n
e c n a i s t s s A
Microphone Connector
s n o I c y a r d n o c e S
g n n i a r W n i o u t a C e i c o t N
Customer Warranty
Assistance
Mounting and Connections
Customer
Assistance
Customer Warranty
Assistance
Customer
Assistance
A universal mounting bracket is supplied along with self tap­
Caution Warning
ping screws and star washers. The transceiver is held in the
universal mounting bracket by two thumb screws, permitting
adjustment at the most con ve nient angle.
To mount and connect your transceiver:
Notice Caution Warning
1. Hold the radio with mounting bracket in the exact
location desired. Remove the mounting bracket
and use it as a template to mark the location for
the mounting screws.
2. Drill necessary holes and secure mounting
bracket in lo ca tion.
3. Connect the antenna cable plug to the re cep ta cle
marked "ANT" on the back of the radio.
4. Connect to the power system in vehicle.
5. Mount the microphone bracket on the right side
of the radio or near it using the two screws supplied.
Place the bracket so the microphone is readily
accessible.
6. Attach the four pin microphone cable to the front of the
radio and install the radio in the bracket securely.
Nothing Comes Close to a Cobra
•
3
®
9/24/15 12:14 PM