Included In This Package; Mounting And Connections - Cobra 19 DX IV EU Owner's Manual

Included in this Package

Introduction
Included in this Package
You should find all of the following items in this package:
CB Transceiver
Transceiver Bracket
Operating Manual
English
2
•
Microphone
Microphone Bracket

Mounting and Connections

Installation and Start-Up Introduction
Mounting and Connections
Select a location for the transceiver and microphone bracket that is con ve nient for
operation. In automobiles, the transceiver is usually mounted to the underneath of the
dash panel, with the microphone bracket beside it.
A universal mounting bracket is supplied along with self tap -
Transceiver Bracket
ping screws and star washers. The transceiver is held in the
universal mounting bracket by two thumb screws, permitting
adjustment at the most con ve nient angle.
To mount and connect your transceiver:
1. Hold the radio with mounting bracket in the exact
location desired. Remove the mounting bracket
and use it as a template to mark the location for
Antenna Connector
the mounting screws.
2. Drill necessary holes and secure mounting
bracket in lo ca tion.
3. Connect the antenna cable plug to the re cep ta cle
marked "ANT" on the back of the unit.
4. Connect to power system in vehicle.
5. Mount the microphone bracket on right side
of the transceiver or near it using two screws supplied.
Microphone Connector
When mount ing in an automobile,
place the bracket under the dash so the
microphone is readily accessible.
6. Attach the four pin microphone cable to receptacle
on front of unit and install unit in bracket securely.
•
Nothing Comes Close to a Cobra
3
®