Table of Contents
Advertisement
setup screen
-
Confirm that the NAS IP address and the camera IP address are in the same format.
ex) The NAS & camera subnet mask initial value is 255.255.255.0.
If the IP address is 192.168.20.32 then the NAS IP address should be in the range of
192.168.20.1~192.168.20.255.
Check whether you tried to access as another user without formatting the default folder saved
-
or used.
Confirm that you used recommended NAS equipment.
-
4. After the settings are completed, set the NAS unit to <On>.
5. Click the [Apply (
6. Log in the NAS and check the <Free size> and <Total size>.
You can format the default folder specified in the NAS connection setting by clicking
the <Format> button.
Since data may not be saved after a temporary network interruption when using NAS, it is
recommended that you use SD at the same time to prevent loss of recorded images.
The data traffic will increase when the camera is set to higher resolution, higher bit rate, and/or higher
framerate.
If there is too much data traffic, some frame may be skipped although it is stored in a full frame.
When a frame skip occurs, images are saved at the rate of min. one image per sec.
94_ setup screen
)] button.
Advertisement
Table of Contents
