Table of Contents
Advertisement
Item
Focus Adjustment
Button
STATUS Indication
Light
Lightning protective
grounding port
Test Monitor Out
Audio terminal
Micro SD Memory
Card Compartment
Network Port
Reset Button
J
RS-485/RS-232 port only supports direct connection with pan/tilt driver and external connections
of the RS-485/RS-232 controller is not supported.
The button adjusts the focus of image automatically.
System boot up : red light is on
Normal working status : green light is on.
Network abnormal status : green light flashes.
Normal recording status : yellow light is on.
Used to discharge the lightning current safely outside in order to protect the
camera.
Output port for test monitoring the video output. Use the test monitor cable
to connect to a mobile display and check the test video.
AUDIO OUT
Used to connect to speakers.
AUDIO IN
Used to connect to a microphone.
Compartment for the Micro SD memory card.
Used to connect the PoE or Ethernet cable for network connection.
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
Description
English _15
Advertisement
Table of Contents
