EN
Changing / removing water from the tank
1.
Set the resistance adjuster handle to MIN
2.
Row at least ten strokes to fill the inner storage reservoir as much as possible with
water.
3.
Remove the tank plug
tank plug.
tank plug
tank plug
4.
Insert the siphon rigid hose
5.
Insert the siphon flexible hose
6.
Drain the tank (approx. 40% of water will remain in the tank. It is not possbile to
drain the tank completely without disassembling the tank)
7.
Refill the tank following the directions as described under the section "Filling the
tank" of this manual.
NOTE
NOTE
NOTE
NOTE
The valve on top of the siphon must be closed to allow proper drainage.
⇒
If the water treatment schedule is maintained, it will not be necessary to
⇒
change the water inside the tank. An additional water treatment tablet is
only required when discoloration of the water appears.
Exposure to sunlight affects the water. Moving the rower away from direct
⇒
sunlight will extend time between water treatments.
16
rigid hose end into the tank
rigid hose
rigid hose
flexible hose end into a large bucket.
flexible hose
flexible hose
MIN.
MIN
MIN
ROW 8.1