Table of Contents
Advertisement
Model W1824 10" Hybrid Table Saw
5. Remove the (6) cap screws, flat washers, and lock
washers from both sides of the main table.
6. Inspect the extension wings and main table mating
surfaces for burrs or foreign materials that may
inhibit assembly.
For a correct fit, the mating edges of the table and
wings must be clean, smooth, and flat. If necessary,
use a wire brush or file to remove any flashing,
dings, or high spots.
7.
While a helper holds the extension wings in place,
attach them to the main table with the (6) M10-1.5
x 25 cap screws, 10mm lock washers, and 10mm flat
washers removed in Step 5, as shown in Figure 14.
8. Place a straightedge across the extension wings and
main table to make sure that the combined table
surface is flat.
— If the combined table surface is flat, skip to
Step 9.
— If the outside end of the extension wing tilts
down, place one or more strips of masking tape
along the bottom edge of the main table to shim
the end of the extension wing up (see Figure 15).
— If the outside end of the extension wing tilts up,
place one or more strips of masking tape along the
top edge of the main table to shim the end of the
extension wing down (see Figure 16).
Note: After reinstalling wings, remove all excess
masking tape with a razor blade.
Figure 14. Extension wings attached.
Figure 15. Masking tape location for
shimming the wing up.
Figure 16. Masking tape location for
shimming the wing down.
-17-
Extension Wings
x6
Advertisement
Table of Contents
