Konica Minolta bizhub 4750 User Manual page 19

2.2 Installation location and environment
Do not install this machine in the locations described below.
- Location exposed to direct sunlight
- Location in which excessive differences in temperature and humidity are detected due to close prox-
imity to a heater or cooling equipment
-
Location exposed to direct flame or combustible materials
-
Location close to equipment such as a copy machine or air-conditioner that generates noise, or equip-
ment such as a refrigerator that generates a strong magnetic or electromagnetic force
-
Location close to water, water pipes, or fluid (drink) containers, corrosive chemicals, or corrosive gases
such as ammonia
-
Location in which fine metallic pieces such as clips or staples are scattered
-
Location subject to thumping vibrations
Tips
-
Do not connect to the same power outlet as that used for a high-current equipment.
-
If this machine is installed in or moved to an environment subject to excessive changes in temperature,
condensation will form in this machine, which may reduce printing quality. If condensation is detected,
leave this machine for approximately 1 hour before using it to adjust to the environment.
-
When using a humidifier or vaporizer in the room where this machine is installed, use purified or distilled
water. If impurities in water are emitted into the air, they will collect in this machine and reduce printing
quality.
[Introduction]
2
2-4