How To Install The Refrigerator; Door Alignment; After Leveling The Door Height; Tools You Need - Kenmore 795.51022.001 Service Manual

3. HOW TO INSTALL THE REFRIGERATOR

1.

DOOR ALIGNMENT

Before adjusting the doors, remove the Base Grille.
If the freezer compartment door is lower than
the refrigerator compartment door, make them
level by inserting flat blade screwdriver into the
groove of the left leveling leg and rotating it
clockwise.
Left leveling
leg
If the freezer compartment door is higher than the
refrigerator compartment door, make them level by
inserting flat blade screwdriver into the groove of
the right leveling leg and rotating it clockwise.
Height
difference
Height
difference
Height
difference
Height
difference
Left leveling leg
Adjust the level when the refrigerator door is lower than
the freezer door during the installation of the refrigerator.

Tools you need

• Wrench 5/16 in (8 mm)
• Wrench 3/4 in (19 mm)
Height
difference
Height
difference
Using a ¾" (19 mm) wrench, turn the keeper nut clockwise
to lossen the keeper nut.
Using a 5/16" (8 mm) wrench, turn the adjustment hinge pin
clockwise or ounterclockwise to level the c
freezer door.
After adjusting the level door, turn the keeper nut
counterclockwise to tighten.
Do not over tightening the door adjustment screw. The
hinge pin can be pulled out. (Adjustable range of height is a
maximum of ½" (1.27 cm)).

AFTER LEVELING THE DOOR HEIGHT

Make sure the front leveling legs are completely
touching the floor.
- 7 -
Keeper nut
Wrench
Up
Adjustment
hinge pin
Down
refrigerator and