Control The Amount Of Water Supplied To The Icemaker; Water Supplying Time Control Option - Kenmore 795.51022.001 Service Manual

3-2 Control the amount of water supplied to the icemaker.

Caution: • Unplug the power cord from the wall outlet and wait at least three minutes before removing the main PWB cover.
310 Volts are present in the control panel.

Water Supplying Time Control Option

DISP S/W
No
S1 S2
1 OFF OFF
2 ON OFF
3 OFF ON
4 ON ON
1) The water supplying time is set at 9s when the refrigerator is delivered.
2) The amount of water supplied depends on the setting time and water pressure (city water pressure).
3) If the ice cubes are too small, increase the water supplying time. This happens when too little water is supplied into the ice tray.
4) If the ice cubes stick together, decrease the water supplying time. This happens when too much water is supplied into the ice
tray.
Caution: When adjusting the amount of water supplied, adjust step by step. Otherwise the water may spill over.
3. When the adjustment of the control switch for the amount of water supplied is complete, check the level of water in the ice.
Water Supply Time
9.0
8.0
10.0
11.0
Switch ON
ON
Switch OFF 1 2
Note
DIP S/W Setting will be depend of
water pressure
- 11 -