Advertisement
Chapter 3
Configuration
Parameter configuration
The following sections provide step-by-step instructions for configuring each
parameter.
<CR> — Refresh The Screen
Type Enter to clear the screen and re-display the current displayed Menu.
1 — Reset the Module
If you have changed certain parameters of the P110 NMA, P113F, or other switches
in the stack, you must reset the agent before you exit the Setup session. The
following lists the resets you must initiate and the resets performed automatically
by the agent.
Resets You must Initiate
Change in the "Use" switch
or any other DIP switch after
setting the 100Mbps port
parameters in the P113F to
their default values
Resetting the agent does not affect any other parameters. You will be asked to
confirm the reset before it is executed.
*** Reset the Agent ***, Confirm [y/n]?
The preferred and most reliable method of ensuring that configuration
changes are saved, is by resetting the agent through the Setup menu, rather
than by pressing the Reset button on the agent panel.
20
Resets Performed Automatically by
the Agent
The first time you set VLANs
After setting Ethernet ports or all
ports to their default values
After a port mode change in one of
the 100Mbps ports in the P113F
P113F Stackable Switch Installation Guide
Advertisement
