Paradyne 6512 Installation Instructions Manual page 12

Connecting a 2-Line Phone (with One or Two Superlines)
Hardware Required (Supplied)
14-foot RJ11 phone cable.
Hardware Required (Not Supplied)
Two additional RJ11 phone cables to connect Lines 1 and 2 of your 2-line phone to
your adapter.
Procedure
Use the following procedure and supporting figure to connect your SuperLine Adapter
to a single phone with two lines. This configuration can be used if you have one or two
additional phone lines through your SuperLine Adapter.
Line 1:
Plug one end of the 14-foot phone cable into the LINE jack on the adapter rear
panel.
Insert the other end of the phone cable into the wall jack.
Install a phone filter on your existing phone (refer to
Your Existing Phones
Connect Line 1 of your 2-line phone into the BASE PHONE jack on the adapter
rear panel.
Line 2:
Connect Line 2 of the 2-line phone into the PHONE 1-2 jack on the rear of the
adapter.
NOTE:
Do not use a 4-wire phone cable to connect phones, faxes, or modems to the
PHONE 1-2 jack. A 4-wire phone cable connected to the PHONE 1-2 jack may
cause interference on phones, faxes, or modems connected to the PHONE 2 jack.
Second Phone, Fax, Modem, or Line 3:
If you have purchased two superlines, you can connect a second phone, fax,
modem, or Line 3 of a 3-line phone into the PHONE 2 jack on the adapter rear
panel.
To complete your SuperLine Adapter installation, refer to
page 21.
on page 17).
12
Connecting Phone Filters to
Applying Power to the Unit
on