Control Knobs; Oven Light Bulb - Jenn-Air W122 Use And Care Manual

Self-cleaning radiant bake and convection oven
Hide thumbs Also See for W122:
Table of Contents

Advertisement

Other
Hints
on
Caring
for Your Oven
Cleaning
Other
Surfaces
of Your
Oven
l)oor
and
control
panel
trim:
The metal trim around the door and the control
panel can be cleaned with any nonabrasive
cleansers such as Bon-Ami
or soapy
water; rinse well. Be careful not to use an excessive amount of water.
Glass
on the
control
panel
front
and oven
door
front:
To clean, use any
suitable glass cleaner or soapy water. To prevent moisture from getting
behind the
glass control panel, spray a cloth with glass cleaner then wipe the panel.
Control
Knobs:
The knobs on the control panel can be removed with the controls in the OFF position.
Pull each knob straight from the shaft. Clean knobs with a hot sudsy cloth then dry. To
replace each knob, match flat part of knob opening
with the spring on the shaft,
returning
in OFF position.
Oven
Light
Bulb
Before replacing
bulb, disconnect
power to oven at the main fuse or circuit breaker
panel
Be sure that the entire oven cavity including
the light bulb is cool before
attempting
to remove.
To replace
light
builD:
1. Carefully
remove the glass light lens and lens
retainer by removing
the two screws in the light
lens retainer using a phillips screwdriver. Note: The
light lens is separate from the light lens retainer.
The two pieces will drop down into your hands at
the same time. Do NOT remove the remaining two
screws.
2. To obtain firm grasp on bulb, wear protective
rubber gloves. Remove by turning bulb to the left.
Do not touch a hot oven fight bulb with a damp
cloth as bulb will break. Note: If the bulb does
break and you wish to remove it, be certain power
supply is disconnected and wear protective gloves.
You may contact your authorized Jenn-Air Service
Contractor for service.
3. Replace bulb with a 40 watt oven-rated
appliance
bulb. Bulb with brass base is recommended
to
prevent fusing of bulb into socket.
4. Place light lens inside of light lens retainer. Hold-
ing the light lens and lens retainer in place, insert
the two screws into the light lens retainer and
tighten.
24

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

W266W 246

Table of Contents