Jenn-Air W122 Use And Care Manual page 21

6. The oven CLEAN INDICATOR LIGHT will glow when all steps are completed
properly, except when set for a delayed start. The light goes off when stop time is
reached.
7. The cleaning process begins immediately unless the self-cleaning process has been
set for a delayed start. When the oven temperature reaches 550°F, the LOCK
INDICATOR LIGHT will glow and the door cannot be opened until the temperature
drops below 550° F. DO NOT TRY TO UNLOCK THE DOOR WHILE LOCK INDI-
CATOR LIGHT IS ON. The normal cleaning process takes the time selected on the
clock plus about 45 minutes for the oven to cool down before the LOCK INDICA-
TOR LIGHT goes out and the door can be opened.
8. After the LOCK INDICATOR LIGHT goes out:
Model W122 -- depress the DOOR LOCK SWITCH while simultaneously moving
the DOOR LOCK LEVER to the left.
Model W266 -- move the DOOR LOCK LEVER to the left.
The oven door can now be opened.
9. Turn the SELECTOR and TEMPERATURE knobs from CLEAN to OFF after the
door is unlocked.
IMPORTANT: IF THE TEMPERATURE KNOB IS TURNED TO OFF BEFORE THE
DOOR IS UNLOCKED, THEDOOR WILL NOTOPEN. Forcing the lock will damage
the lock mechanism. Return TEMPERATURE knob to CLEAN, unlock the door,
then turn TEMPERATURE knob OFF.
NOTE: A fan comes on whenever the SELECTOR knob is set to CLEAN. There-
fore, the fan will continue to operate at the end of the cleaning process until the
SELECTOR knob is turned OFF. The fan will also start as soon as the controls are
set for a delayed start of the self-cleaning process.
To stop cleaning process before lock indicator light
colnes ont
1. Model W122 -- Depress DOOR LOCK SWITCH while simultaneously moving the
DOOR LOCK LEVER to the left.
Model W266 -- Move the DOOR LOCK LEVER to the left.
2. Turn SELECTOR and TEMPERATURE knobs from CLEAN to OFF.
3. Turn STOP time dial until it pops out. Pointer should be at the same time of day as
the oven clock.
To stop cleaning process after lock indicator light
comes on:
1. Turn the STOP time dial until the knob pops out and the CLEAN INDICATOR
LIGHT goes out.
2. Leave the TEMPERATURE and SELECTOR knobs in the CLEAN position.
3. Allow oven to cool until the LOCK INDICATOR LIGHT goes out. This may take up to
45 minutes, depending on how long the oven has been on.
4. After LOCK INDICATOR LIGHT goes off:
Model W122 -- depress the DOOR LOCK SWITCH while simultaneously moving
the DOOR LOCK LEVER to the left.
Model W266 -- move the DOOR LOCK LEVER to the left.
5. Turn SELECTOR and TEMPERATURE knobs from CLEAN to OFF.
NOTE: When SELECTOR knob is turned to CLEAN, a fan comes on. If this fan is
not operating, the oven will go through the self-cleaning process at a reduced oven
temperature and the oven will not clean effectively. If the fan does not operate
contact your Jenn-Air Authorized Service Contractor for service.
22