Figure 16 Wan Ip Settings - SmartRG SR10 User Manual

SmartRG™ Residential Gateways
6. For IPoE WAN services select "Obtain an IP address automatically" (DHCP) or select "Use
the following Static IP address" and enter the "WAN IP Address", "WAN Subnet Mask" and
"WAN gateway IP." Click Next.

Figure 16 WAN IP Settings

7. If desired enable the firewall, NAT and IGMP Multicast.
IMPORTANT For IPTV configurations (either bridged or routed) as detailed in, "Use Case: Setting
Up Wireless Distribution System (WDS)
When deployed in a larger home or office, a single wireless access point may not be
able to provide adequate Wi-Fi coverage. Wireless Distribution Systems (WDS)
provides a solution for this problem. WDS combines multiple gateways to act as a
single larger wireless access point allowing Wi-Fi clients to seamlessly roam all
access points plus provides wired access to the entire network.
Two or more SmartRG gateways can be configured for WDS operation. The example
below depicts a WDS deployment with three SmartRG gateways in a large home or
office – one primary gateway in the center of the building and one remote gateway
at either end of the building.
P a g e | 24 C o n f i d e n t i a l S m a r t R G © 2 0 1 2