Configuring The Layer 2 Interface (Vdsl/Ptm); Figure 13 Vdsl Layer 2 Interface Configuration - SmartRG SR10 User Manual

SmartRG™ Residential Gateways
7. IMPORTANT - Check "Enable Quality of Service" if you intend to support QoS classified
traffic through the WAN service.
8. Click Apply/Save.
NOTE Enabling QoS for routed IPTV service configurations will improve channel change
performance.

Configuring the Layer 2 Interface (VDSL/PTM)

To configure a VDSL / PTM layer 2 interface:
1. Select Advanced Setup -> Layer2 Interface -> PTM Interface and click Add.

Figure 13 VDSL Layer 2 Interface Configuration

2. Select the "DSL Latency" – Path0 is typical.
3. Select the "PTM Priority" – Normal Priority is typical.
4. Select the "Connection Mode" – Default Mode is typical (when VLAN segmentation is not
required).
5. IMPORTANT - Check "Enable Quality of Service" if you intend to support QoS classified
traffic through the WAN service.
P a g e | 20 C o n f i d e n t i a l S m a r t R G © 2 0 1 2