Before Use - Panasonic MJ-L500 Operating Instructions Manual

Before Use

-Disassembly and assembly of the parts-
Disassembling/Assembling attachments
●
The following steps show how to disassemble/assemble attachments, using the juice attachment as
an example.
The frost attachment can be disassembled/assembled in the same method.
To disassemble
1
Remove the
bowl from the
motor housing.
2
Remove the juice
attachment.
●
Squeezing screw comes out with it.
Squeezing
Screw
(
Frost
attachment
3
Remove the parts.
Filter
(
Frost
attachment
Rotating
brush
GB12
1
Make sure the gasket, rubber
plug and rubber brushes are
in place correctly.
●
Gasket is located in the juicing bowl.
Top view
●
Rubber plug is located outer bottom.
Push it in until
no gap.
)
Outer bottom view
●
Rubber brushes are located on side of the
rotating brush.
See page GB19 for how to install the gasket,
rubber plug and rubber brushes.
●
The juicer may not work properly if
)
they are not assembled correctly.
To assemble
2
Set the juicing bowl on the motor
housing.

Align the " " mark on the motor housing and

the " " on the juicing bowl.
3
Attach the rotating brush and filter,
then set it on the motor housing.

Align the " " mark on the motor housing and

the " " mark on the juice attachment.
Top view
4
Mount the squeezing screw.
I nsert the squeezing screw into the centre.
1
R otate the squeezing screw and push it into
2
the hole until it stops.
●
The lid cannot be closed if the squeezing
screw is not pushed down sufficiently.
●
Be careful not to get your finger clamped in
the gap between the squeezing screw and
the filter.
( )
Frost
attachment
① ●
② ●
GB13