Heat & Glo PRIMO48 Owners Manual Care And Operation page 20

Removing Firebox Glass Assembly
1. Remove the transition media from the appliance. Lift
the transition media tray out of appliance. Disconnect
the wires that are connected to the reset switch. The
transition media tray fi ts tightly, lift carefully. See Fig-
ure 4.6.
2. Locate the glass clips that are on the upper edge of
the glass frame of the appliance. See Figure 4.6.
3. Use both index fi ngers to release the glass clips.
4. Allow glass to tilt forward. Lift up and out. The glass
will lift out of the bottom retaining lip.
Replacing Firebox Glass Assembly
1. Locate retaining lip on lower front face of fi rebox.
Note: Remove any media that may have fallen into the
glass retaining lip.
2. Place glass assembly into retaining lip. Tilt top of
glass assembly toward fi replace.
3. Assure proper left to right placement of glass and en-
gage all four spring latches.
Figure 4.6 Location of Glass Clips and Transition Media Tray
20 Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Owner's Manual • 2310-971 Rev. G • 9/15
GLASS CLIPS
TRANSITION MEDIA TRAY
TRANSITION MEDIA TRAY
ROCK LEDGE
Firebox Gasket Seal and Firebox Glass
Assembly Inspection
Frequency: Annually
By: Qualifi ed Service Technician
Tools needed: Protective gloves, suction cups, drop cloth
and a stable work surface.
• Inspect condition of gasket seal.
• Inspect fi rebox glass for scratches and nicks that can
lead to breakage when exposed to heat.
• Confi rm there is no damage to glass or glass frame.
Replace as necessary.
• Verify that firebox glass is properly retained and
attachment components are intact and not damaged.
Replace as necessary.
Firebox
Frequency: Annually
By: Qualifi ed Service Technician
Tools needed: Protective gloves, sandpaper, steel wool,
cloths, mineral spirits, primer and touch-up paint.
• Inspect for paint condition, warped surfaces, corrosion
or perforation. Sand and repaint as necessary.
• Replace fi replace if fi rebox has been perforated.
Control Compartment and Firebox Top
Frequency: Annually
By: Qualifi ed Service Technician
Tools needed: Protective gloves, vacuum cleaner, dust
cloths
• Vacuum and wipe out dust, cobwebs, debris or pet hair.
Use caution when cleaning these areas. Screw tips that
have penetrated the sheet metal are sharp and should
be avoided.
• Remove all foreign objects.
• Verify unobstructed air circulation.