Heat & Glo PRIMO48 Owners Manual Care And Operation page 19

Removing Barrier Glass - Black Granite Finish
1. Slide side granite pieces inward toward center of fi re-
place to disengage from the key slots. See appliance
installation manual.
2. Remove (unscrew) D-shaped retaining tabs.
3. The glass rests against the barrier glass support
bracket. See Figure 4.3.
4. Use suction cups to remove barrier glass.
5. Rotate/tilt the bottom of the glass outward to remove.
See Figure 4.2.
6. Set the glass on a prepared work surface.
D-SHAPED RETAINING TAB
LOCATED BEHIND GRANITE
GLASS SUPPORT
BRACKET
BARRIER GLASS
NOTE: INSTALL BARRIER
GLASS PRINTED SIDE
OUT."THIS SIDE OUT" MUST
BE LEGIBLE ON BARRIER
GLASS.
Figure 4.3 Remove Barrier Glass - Black Granite Finish
Figure 4.4 Glass Gasket Detail - Black Granite Finish
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Owner's Manual • 2310-971 Rev. G • 9/15
GLASS GASKET BULB
GLASS GASKET BULB GLASS GASKET BULB
BARRIER GLASS TABS
NOTE: INSTALL BARRIER
GLASS PRINTED SIDE
OUT."THIS SIDE OUT"
MUST BE LEGIBLE ON
BARRIER GLASS.
Figure 4.5. Replace Barrier Glass - Clean Face Finish
TOP TOP
BOTTOM BOTTOM
19