Error Messages On The Screen - Fujitsu Siemens Computers Lifebook E Series Easy Manual
Hide thumbs
Also See for Lifebook E Series:
- User manual (97 pages) ,
- Easy manual (43 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Troubleshooting and tips
Error messages on the screen
This section describes the error messages generated by the BIOS-Setup. Error messages displayed
by the operating system or programmes are described in the relevant manuals.
CMOS Battery Bad
If the error message occurs repeatedly, then the buffer battery in the notebook is flat.
Ê
Connect the notebook via its power adapter to the mains outlet. The buffer battery will take
approximately two days to complete its recharge.
If the error message appears repeatedly, please contact the place of purchase or our Hotline/Help
Desk.
System CMOS checksum bad – Default configuration used
The system configuration information is incorrect.
Ê
Switch the notebook off.
Ê
Switch the notebook on.
Ê
Enter the BIOS Setup programme by pressing [F2]
Ê
Select the Exit menu in the BIOS Setup.
Ê
Select the Default Setup entry and click on OK.
If the error message appears repeatedly, please contact the place of purchase or our Hotline/Help
Desk.
Insert system diskette and press Enter key to reboot
The operating system cannot be loaded or the hard disk contains no operating system or is not
formatted.
Ê
Insert a system disk.
Ê
Press any key to continue.
Invalid system disk - Replace the disk, and then press any key
The inserted disk is not a system disk or the inserted system disk is defective.
Ê
Insert another system disk.
Ê
Press any key to continue.
If you wish to boot from floppy disk:
Ê
Insert a system disk.
Ê
Press any key to continue.
Diskette drive A error
Ê
Start the BIOS Setup and make sure that the parameter for floppy disk drive A has been set to
the format 1.44 Mbyte, 3 1/2 inch.
Extended memory failed at offset: xxxx Failing Bits: zzzz zzzz
When testing the extended memory an error has resulted at the address xxxx.
Ê
Check whether the additional memory module has been inserted correctly.
Should you receive this error message again, please contact your dealer.
58
[F2].
[F2]
[F2]
A26391-K114-Z120-1-7619
Advertisement
Table of Contents
