Error Messages On The Screen - Fujitsu Siemens Computers CELSIUS Mobile H230 Operating Manual

Error messages on the screen

This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programmes are described in the relevant documentation.
CMOS Battery Bad
If the error message occurs repeatedly, then the buffer battery in the notebook is dead.
Please contact your sales outlet or our Hotline/Help Desk.
System CMOS checksum bad - Default configuration used
The system configuration information is incorrect.
► Switch the notebook off.
► Switch the notebook on.
► Enter the BIOS Setup by pressing F2 .
► Select the Exit menu in the BIOS Setup.
► Select the entry Load Setup Defaults.
► Select OK and press the Enter key.
If the error message appears repeatedly, please contact the place of purchase or our customer
service centre.
Extended memory failed at offset: xxxx Failing Bits: zzzz zzzz
When testing the extended memory an error has resulted at the address xxxx.
► Check whether the additional memory module has been inserted correctly.
If this error message appears again, please contact your sales outlet or our Hotline/Help Desk.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
► Start the BIOS Setup (Primary Master submenu) and select the correct settings.
Keyboard controller error
► Switch off the notebook with the Suspend/Resume button.
► Wait 3 - 5 seconds and switch on the notebook again.
If this error message appears again, please contact your sales outlet or our Hotline/Help Desk.
A26391-K169-Z121-1-7619, edition 1
Troubleshooting and tips
109