DFI LanParty DK P35 Series User Manual page 24

English
Restarting the PC
Normally, you can power-off the PC by:
1. Pressing the power button at the front panel of the chassis.
or
2. Pressing the power switch that is on the system board (note:
not all system boards come with this switch).
If for some reasons you need to totally cut off the power supplied
to the PC, switch off the power supply or unplug the power cord.
Take note though that if you intend to restar t it at once, please
strictly follow the steps below.
1. The time where power is totally discharged varies among
power supplies. It's discharge time is highly dependent on the
system's configuration such as the wattage of the power supply,
the sequence of the supplied power as well as the number of
peripheral devices connected to the system. Due to this
reason, we strongly recommend that you wait for the Standby
Power LED (refer to the "LEDs" section in this chapter for the
location of the Standby Power LED) to lit off.
2. After the Standby Power LED has lit off, wait for 6 seconds
before powering on the PC.
If the system board is already enclosed in a chassis which ap-
parently will not make the Standby Power LED visible, wait for
15 seconds before you restore power connections. 15 seconds
is approximately the time that will take the LED to lit off and
the time needed before restoring power.
The above will ensure protection and prevent damage to the
motherboard and components.
24