DFI LanParty DK P35 Series User Manual page 19

Floppy Disk Drive Connector and IDE Connector
PCI 1
PCI 2
PCI 3
Floppy Disk Drive Connector
The floppy disk drive connector is used to connect a floppy drive.
Inser t one end of the floppy cable into this connector and the
other end-most connector to the floppy drive. The colored edge
of the cable should align with pin 1 of this connector.
IDE Disk Drive Connector
The IDE disk drive connector is used to connect 2 IDE disk drives.
An IDE cable have 3 connectors on them, one that plugs into this
connector and the other 2 connects to IDE devices. The connec-
tor at the end of the cable is for the Master drive and the connec-
tor in the middle of the cable is for the Slave drive. The colored
edge of the cable should align with pin 1 of this connector.
Note:
When using two IDE drives, one must be set as the master and
the other as the slave. Follow the instructions provided by the
drive manufacturer for setting the jumpers and/or switches on the
drives.
40
33
34
1
39
2 1
IDE
FDD
English
1
2
19