DFI LanParty DK P35 Series User Manual page 20

English
IrDA and Serial (COM) Connectors
2
1
IrDA Connector
This connector is used to connect an IrDA module.
You may need to install the proper drivers in your operating
system to use the IrDA function. Refer to your operating system's
manual or documentation for more information.
Serial (COM) Connector
The serial (COM) connector is used to connect modems, serial
printers, remote display terminals, or other serial devices. Your
COM port may come mounted on a card-edge bracket. Install the
card-edge bracket to an available slot at the rear of the system
chassis then connect the serial por t cable to this connector. The
colored edge of the cable should align with pin 1 of this
connector.
20
IRRX
N. C. Ground
VCC
IRTX
1 5
IrDA
COM 1
9
Note:
The sequence of the pin functions on some IrDA cable may be
reversed from the pin function defined on the system board.
Make sure to connect the cable connector to the IrDA connector
according to their pin functions.
PCI 1
PCI 2
PCI 3
1