DFI LanParty DK P35 Series User Manual page 26

English
PWR-LED: Power/Standby LED
When the system's power is on, this LED will light. When the
system is in the S1 (POS - Power On Suspend) or S3 (STR -
Suspend To RAM) state, it will blink every second.
HD-LED
(Primary/Secondary IDE LED)
Reserved
ATX-SW
(ATX power switch)
Reserved
RESET
(Reset switch)
SPEAKER
(Speaker connector)
PWR-LED
(Power/Standby LED)
DRAM Power LED
This LED will light when the system's power is on.
Standby Power LED
This LED will light when the system is in the standby mode.
26
Note:
If a system did not boot-up and the Power/Standby LED did not
light after it was powered-on, it may indicate that the CPU or
memory module was not installed properly. Please make sure
they are properly inserted into their corresponding socket.
Pin
Pin Assignment
3
HDD LED Power
5
HDD
14
N. C.
16
N. C.
8
PWRBT+
10
PWRBT-
18
N. C.
20
N. C.
7
Ground
9
H/W Reset
13
Speaker Data
15
N. C.
17
Ground
19
Speaker Power
2
LED Power (+)
4
LED Power (+)
6
LED Power (-) or Standby Signal