Chapter 1
Introduction to the CR-180
N Rear View
To avoid overheating and causing a fire, never block the air vents on the back of the
scanner.
CAUTION
N Connectors
DIP switch
This switch is for setting the
SCSI ID. (See "Setting the
SCSI ID," on p.18.)
14
Connectors
Air Vent
SCSI connector
Connect a half-pitch 50 pin
SCSI cable. (See "Connecting
the SCSI Cable," on p.18.)
Power Cord Connector
Connect the power cord provided with
the scanner to this connector.
USB connector
Connect a Hi-Speed USB 2.0
compatible cable. (See
"Connecting the USB Interface
Cable," on p.20.)