Download Print this page

Da-Lite Da-Snap 74610 Instruction Book page 4

Advertisement

INSTALLATION
Method 2
1. Use the supplied #10 screws to attach four frame
brackets to the back of the frame as shown in
figure 5.
#10 SCREWS
8-PIECES
FIGURE 5
2. Secure the wall bracket to wall studs at the
desired height. Make sure the bracket is level.
The top of the frame will be 1/8" above the top of
the wall bracket when mounted. You will need at
least 5/8" clearance above the bracket to hang the
screen.
3. To install the lower wall bracket, you must
measure the overall height of the screen frame
and subtract 1/4". This is the dimension from the
top of the upper wall bracket to the bottom of the
lower wall bracket. See figure 6.
FIGURE 6
OVERALL HEIGHT
4. Unroll the screen on a clean surface. Do not use
newspaper. The viewing side is rolled to the
inside of the roll. Place the frame over the screen
surface, and while lifting the frame with one
hand, snap the screen surface onto the frame
with the other hand while maintaining a steady
pull on the surface.
FRAME BRACKETS
4-PIECES
WALL BRACKET
2-PIECES
OVERALL HEIGHT -1/4"
5. Position the screen with the attached surface
onto the top wall bracket as shown in figure 7.
Push down at the center of the bottom frame rail
to hook onto the lower wall bracket.
FIGURE 7
Method 3
1. Use the supplied #10 screws to attach six frame
brackets to the back of the frame as shown in
figure 8.
2. Secure the wall brackets to wall studs at the
desired height. Make sure the brackets are level.
The top of the frame will be 1/8" above the top of
the wall bracket when mounted. You will need at
least 5/8" clearance above the bracket to hang the
screen.
3. To install the lower wall bracket, you must
measure the overall height of the screen frame
and subtract 1/4". This is the dimension from the
top of the upper wall bracket to the bottom of the
lower wall bracket. See figure 6.
4. Some large screen sizes are made with 2-piece
side frame rails. For this type of frame you will
need to attach one High Power bracket to each
side at the joint. See figure 8.
#10 SCREWS
12-PIECES
FIGURE 8
3
1
2
FRAME BRACKETS
6-PIECES
WALL BRACKETS
3-PIECES
HIGH
POWER
BRACKET
FOR
LARGE
SPLIT
FRAMES
ONLY.
2-PIECES

Advertisement

loading