Self Diagnostic Codes - Kyocera FS-1030MPF Service Manual

(2) Self diagnostic codes

Code
0030 FAX control PWB system error
Processing with the fax software
was disabled due to a hardware
problem.
0070 FAX control PWB incompatible
detection Error
Abnormal detection of FAX control
PWB incompatibility In the initial
communication with the FAX control
PWB, any normal communication
command is not transmitted.
0100 Backup memory device error
0120 MAC address data error
0130 Backup memory read/write error
0140 Backup memory data error
0150 Control PWB EEPROM error
Detecting control PWB EEPROM
(U17) communication error.
0170 Billing counting error
Contents
Causes
Defective FAX Replace the FAX control PWB (See
control PWB. page 1-5-48).
Defective fax Install the fax software.
software.
Defective FAX Replace the FAX control PWB (See
control PWB. page 1-5-48).
Defective flash Replace the control PWB (See page 1-
memory. 5-37).
Defective control Replace the control PWB (See page 1-
PWB. 5-37).
Defective flash Replace the control PWB (See page 1-
memory. 5-37).
Defective flash Replace the control PWB (See page 1-
memory. 5-37).
Defective control Replace the control PWB (See page 1-
PWB. 5-37).
Defective flash Replace the control PWB (See page 1-
memory. 5-37).
Defective control Replace the control PWB (See page 1-
PWB. 5-37).
Improper installa- Check the installation of the EEPROM
tion control PWB (U17) and remedy if necessary (See
EEPROM (U17). page 1-5-37).
Defective control Replace the control PWB (See page 1-
PWB. 5-37).
Data damage of Contact the Service Administrative Divi-
control PWB sion.
EEPROM (U17).
Defective control Replace the control PWB (See page 1-
PWB. 5-37).
Data damage of Contact the Service Administrative Divi-
control PWB sion.
EEPROM (U17).
1-4-4
2MH/2MJ/2MK/2ML
Remarks
Check procedures
/corrective measures