Telephone base installation
Install the telephone base as shown below.
5.
Plug the other end
of the telephone line
cord into a telephone
wall jack.
If you have DSL high
speed Internet service, a
DSL filter (not included)
is required.
.
Route the telephone
line cord through the
channel.
IMPORTANT INFORMATION
1.
Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, please call the appropriate number listed below based on your
location: If you live in CT, please call
GA, KY, LA, MS, NC, SC or TN, please call
states, please call
.
The power adapters are intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
.
Plug one end of the telephone line
cord into the telephone jack on the
bottom of the telephone base.
1 (800) 667-2118
1 (800) 508-9995
1 (800) 733-2355
.
6.
Plug the large end
of the power adapter
into a power outlet
not controlled by a
wall switch.
1.
Plug the small end
of the power adapter
into the power jack
on the bottom of the
telephone base.
.
Route the power
adapter cord through
the channel.
.
If you live in AL, FL,
.
For all other
Need help?
Do you have a question about the DECT AT3211-2 and is the answer not in the manual?