Installation Preparation - AT&T DECT AT3211-2 Quick Start Manual

Installation preparation

You must install and charge
the battery before using the
telephone.
Install the telephone base close to a telephone jack and a power outlet not
controlled by a wall switch. For optimum range and better reception, place the
telephone base in a central and open location.
If you subscribe to high-speed Internet service (digital subscriber line -
DSL) through your telephone line, you must install a DSL filter between the
telephone line cord and the telephone wall jack (see the following page). The
filter prevents noise and caller ID problems caused by DSL interference. Please
contact your DSL service provider for more information about DSL filters.
Your product may be shipped with a protective sticker covering the handset or
telephone base display - remove it before use.
For customer support, please call the appropriate number listed below based
on your location: If you live in CT, please call
in AL, FL, GA, KY, LA, MS, NC, SC or TN, please call
all other states, please call
Avoid placing the telephone base too close to:
• Communication devices such as: television sets, VCRs, or other cordless
telephones.
• Excessive heat sources.
• Noise sources such as a window with traffic outside, motors, microwave
ovens, refrigerators, or fluorescent lighting.
• Excessive dust sources such as a workshop or garage.
• Excessive moisture.
• Extremely low temperature.
• Mechanical vibration or shock such as on top of the washing machine or
workbench.
STOP!
1 (800) 667-2118

See pages 5-6
for easy instructions.
1 (800) 508-9995
1 (800) 733-2355
.
. If you live
. For