Rheem *96V series Installation Instructions Manual page 40

3
DRILL (3) Ø 1/8" HOLES
PRE-DRILL (3) Ø 1/8" HOLES AS SHOWN FOR CONDENSATE TRAP.
4a
DISCARD
METAL BRACKET
AND
.403 DRAIN PLUG
4d
INSTALL
CONDENSATE
TRAP GASKET
NOTE: REMAINING STEPS SHOWN WITH FURNACE IN HORIZONTAL RIGHT ORIENTATION
5
INSTALL
CUT
LINE 2
HOSE "D"
5d
SEE CRITICAL HOSE CLAMP LOCATION NOTE
IN THE GENERAL COVERSION INSTRUCTIONS.
NOTE:
USE SOAPY WATER TO FACILITATE EASY
HOSE AND TUBE ASSEMBLY
40
INSTALL
4c
.559 DRAIN
PLUG
4e
(X3)
4b
DISCARD
HOSE "A"
INSTALL
CUT LINE 1
HOSE "E"
5c
INSTALL
1/4" TUBE CUT
TO FIT (APPROX.
4")
5b
4
NOTE: TO PREVENT DAMAGE TO THE TRAP, THE INSTALLER
MAY ELECT TO INSTALL IT DURING A LATER STEP. (AFTER
THE UNIT IS ROTATED)
4a - REMOVE METAL BRACKET AND.403" DRAIN PLUG - DISCARD.
4b - REMOVE HOSE "A" - DISCARD
4c - INSTALL Ø.559" CONDENSATE DRAIN PLUG
4d - CONDENSATE TRAP GASKET AS SHOWN
4e - NSTALL CONDENSATE TRAP. MAKE SURE THE CHANNEL AT
I
THE LOCATION SHOWN IN THE "IMPORTANT SECTION"
ENGAGES THE EDGE OF THE JACKET AT THE LOCATION
SPECIFIED.
4f - SECURE USING 3 SCREWS.
5a - ROTATE UNIT 90°
5b - CUT 1/4" VENT HOSE TO FIT (APPROX. 6-1/2") AND INSTALL AS SHOWN.
5c - CUT HOSE E AT LINE 1 - INSTALL
NOTE: MAKE SURE CUT IS STRAIGHT AND SQUARE
5d - CUT HOSE D (REMOVED IN STEP1) AT LINE 2 -INSTALL
!! IMPORTANT !!
CONDENSATE TRAP
INFORMATION
THIS CHANNEL
MUST ENGAGE
JACKET AT THIS
EDGE TO AVOID
AIR LEAKS TO
THE BURNER
VESTIBULE!
5a
ROTATE
UNIT 90
ST-A1194-35-01