Rheem *96V series Installation Instructions Manual page 26

11
SEE CRITICAL HOSE CLAMP
LOCATION NOTE IN THE
GENERAL CONVERSION
INSTRUCTIONS.
NOTE:
USE SOAPY WATER TO FACILITATE EASY HOSE AND TUBE ASSEMBLY USE SOAPY WATER TO FACILITATE EASY HOSE AND TUBE ASSEMBLY USE SOAPY WATER TO FACILITATE EASY HOSE AND TUBE ASSEMBLY
12a
OPTION
DRAIN LEFT
SIDE
ATTACH SIDE ATTACH SIDE
"2" TO BULKHEAD "2" TO BULKHEAD
COUPLING COUPLING
2 2
1 1
26
1/4" TUBE CUT 1/4" TUBE CUT
TO FIT (APPROX
HOSE D
ELBOW NOT SHOWN ELBOW NOT SHOWN
FOR CLARITY
TUBE "C"
CUT TO FIT
CABINET WIDTH
HOSE "B"
NOTE: PLIERS NECCESSARY TO ADD OR REMOVE CLAMPS NOTE: PLIERS NECCESSARY TO ADD OR REMOVE CLAMPS NOTE: PLIERS NECCESSARY TO ADD OR REMOVE CLAMPS
11a
10-1/2") )
HOSE E
11a - ROTATE INDUCER COUPLING 10° 11a - ROTATE INDUCER COUPLING 10°
11b - INSTALL CONDENSATE TRAP BY MOUNTING 11b - INSTALL CONDENSATE TRAP BY MOUNTING
11c - CUT 1/4" VENT TUBE TO FIT (APPROX.10-1/2"). 11c - CUT 1/4" VENT TUBE TO FIT (APPROX.10-1/2").
11d - INSTALL HOSE D (REMOVED IN STEP 1) FROM 11d - INSTALL HOSE D (REMOVED IN STEP 1) FROM
11e - ATTACH HOSE E TO THE TOP OF 11e - ATTACH HOSE E TO THE TOP OF
11b
12b
OPTION
DRAIN RIGHT
SIDE
(X3)
APPROXIMATLY 10-20° TILT APPROXIMATLY 10-20° TILT
ON INDUCER COUPLING ON INDUCER COUPLING
10° 10° -20
ROTATE INDUCER COUPLING TO ENSURE ROTATE INDUCER COUPLING TO ENSURE
DOWNWARD FLOW OF CONDENSATE FROM DOWNWARD FLOW OF CONDENSATE FROM
FLUE VENTING
! NOTE: TIGHTEN ELBOW COUPLING CLAMPS TO ! NOTE: TIGHTEN ELBOW COUPLING CLAMPS TO
FLUE PIPE WITH 5/16" NUT DRIVER. (NOT SHOWN) FLUE PIPE WITH 5/16" NUT DRIVER. (NOT SHOWN)
BRACKET TO JACKET USING (2) SCREWS. BRACKET TO JACKET USING (2) SCREWS.
INSTALL AS SHOWN.
TRANSITION COULPLING TO THE FLUE TAP ON TRANSITION COULPLING TO THE FLUE TAP ON
THE CONDENSATE TRAP. THE CONDENSATE TRAP.
CONDENSATE TRAP.
GROUND
HOSE A
ST-A1194-31-04