Zoom 4506 User Manual page 36

•
Ethernet port configuration
Set to LAN by default. You can change this to WAN, Auto, or Off to disable the
Ethernet port. Accept the default if you are using a 3G WAN Type protocol;
otherwise, select WAN. Use Auto if you want the router to detect if the
Ethernet connection is WAN or LAN. Off disables the Ethernet port and is not
recommended.
•
LAN IP Address
The local IP address of the router. 192.168.1.1, by default. All wireless or wired
devices on your network must use the LAN IP address of your router as their
default gateway.
•
3G Failover
You can use the 3G Failover feature if you are using a DSL or Cable modem
and want the router to fall back to a mobile broadband Internet connection in
the event your DSL or Cable connection fails.
Note: To use this feature you must have a 3G modem installed.
To set up the 3G Failover, follow the instructions below:
1
Click the Wan Connection Checkbox.
2
Enter an IP address in the Internet host textbox. This is the IP address
that the router will ping to verify that your DSL or Cable connection is
active. (We recommend using your Domain Name Server for this
purpose.) To get the IP address of your Domain Name server:
a. Go to the Status page from the Zoom Configuration Manager.
36
Locate the Domain Name Server.
Travel Router with Wireless-N User Manual