Cimbali M32 Bistro dt1 Owner's Manual page 39

English
Position a suitable container for the amount to be programmed under
the hot water pipe (5).
Press (and keep momentarily pressed) the hot water dispensing push
button (19). The indicator light of the pressed push button will remain
on (not flashing).
When the amount of water in the container reaches the required level,
release the push button (19).
Using the PROG button:
1 - Alternately press the PROG button until the display shows:
2 - Press the button to program; the display will show:
WATER-SOFTENER RESIN-REGENERATION MESSAGE
When you hear a beep and the message is
displayed:
carry out resin regeneration
Press the ">>>" button for about 8 sec. When you hear the beep, the
message is cleared and "Regeneration Performed" is dispayed.
When the display shows
When the display shows
NOTE: If the messages do not clear, request technical service.
Programming the hot water measures
Machine messages
Resins Regeneration
then press >>>
Machine cold
Please Wait
Irregular dose
19
5
dt 1
Dosage Programing
Press a Button
Selection 01
Water Dosage: 00
Wait for the boiler to reach working pressure
as indicated by the gauge.
Grind size is probably too fine.
Coffee panel pressing is probably too high.
English
19
23
5
dt 2
The LEDs of the buttons to be
programed turn on.
To change, press "+" or "-".