Cimbali M32 Bistro dt1 Owner's Manual page 37

English
" Before programming the coffee dispensing push buttons fill
the filter holder with the correct serving of ground coffee.
Don't use coffee grouts for programming servings. "
Fit and tighten the filter holder (7) on the coffee dispenser unit, posi-
tioning the cup (or cups) under the nozzle (or nozzles) of the filter
holder (7).
Press (and keep momentarily pressed) the coffee dispensing push button
(13, 14, 15 or 16) corresponding to the required serving to be pro-
grammed.
The indicator light of the pressed push button will remain ON (not flash-
ing).
When the amount of coffee in the cup reaches the required level, re-
lease the coffee dispensing push button.
If necessary, repeat the above operations for the other coffee push
buttons.
Using the PROG button:
1 - Alternately press the PROG button until the display shows:
2 - Press the button to program; the display will show:
Position a suitable container for the amount to be programmed under
the cappuccino system (2).
Press (and keep momentarily pressed) the milk dispensing push but-
ton (9). The indicator light of the pressed push button will remain ON
(not flashing).
When the amount of milk in the container reaches the required level,
release the push button (9).
Using the PROG button:
1 - Alternately press the PROG button until the display shows:
2 - Press the Milk button; the display will show:
Programming the coffee measures
Programming the milk measures
13
15
7
Dosage Programing
Press a Button
Selection 01
Water Dosage: 00
9
2
dt 1
Dosage Programing
Press a Button
Selection 01
Milk Dosage: 00
English
16
14
The LEDs of the buttons to be
programed turn on.
To change, press "+" or "-".
9
2
dt 2
The LEDs of the buttons to be
programed turn on.
To change, press "+" or "-".