Chapter 4 RMM1024 Features
This chapter describes the features of RMM1024 monitor. The features of
RMM1024 monitor are as shown in Figure 4-1 after installed and powered on:
Figure 4-1 Features of RMM1024 Monitor
Tally light: this LED light is at the top center of the front panel, and you
1.
can judge the monitor status by the color of Tally light. This tri-color
(red/green/amber) light is controlled through a RJ45 connector on the
rear panel.
Status Information: it is displayed in the top left corner of the screen,
2.
and includes the input channel and signal format. You can define it in
DISPLAY menu.
Waveform and Vector: this is effective only for SDI signal. The
3.
waveform and vector of the input signal are configurable in the MAIN
Menu.
Area Marker: it is used to mark different area of the image. You can set
4.
whether to display it or not and their displaying mode in MARKER menu.
Safe Marker: it is used to mark different area of the image. You can set
5.
whether to display it or not and their displaying mode in MARKER menu
7
RMM1024 Features