Battery Installation And Charging - AT&T TL88002 User Manual

Getting started

Battery installation and charging

Install the battery, as shown on pages 6-7. Once you have installed
the battery, the screen indicates the battery status (see the
following table). If necessary, place the handset in the telephone
base or charger to charge the battery. For best performance, keep
the handset in the telephone base or charger when not in use. The
battery is fully charged after 16 hours of continuous charging. See
the table on page 33 for battery operating times.
If the screen shows Place handset in charger and
need to charge the handset without interruption for at least 30
minutes to give the handset enough charge to use the telephone
for a short time. The following table summarizes the battery charge
indicators and actions to take.
Battery indicators
The screen is blank,
or shows Place
handset in charger
and (flashing).
The screen shows
Low battery and
(flashing).
The screen shows
HANDSET X.
NOTE: If you are on a phone call in low battery mode, you hear four short
beeps every minute.
Step 1
Plug the battery connector
securely into the socket
inside the handset battery
compartment. Insert the
supplied battery with the
label THIS SIDE UP facing
up, as indicated.
Battery status
Battery has no or
very little charge. The
handset cannot be used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place it in the telephone base or
charger when not in use.
6
flashes, you