Table of Contents
Advertisement
Sending an Emergency Alarm
This feature allows you to send a data transmission, which
identifies the radio sending the emergency, to the dispatcher.
Procedure:
1 Press the preprogrammed Emergency button. A tone
sounds and the display alternates Emergency and the
home display.
2 A dispatcher acknowledgment Ack received display
follows.
AND, Trunking Only:
A high-pitched tone indicates that the alarm has been
received by the trunked system's central controller.
3 Press and hold the emergency button or the PTT button to
return to normal operation.
Sending an Emergency Call (Trunking Only)
Procedure:
1 Press preprogrammed Emergency button.
2 A tone sounds and the display alternates Emergency and
the home display.
OR
A short low-pitched tone sounds when the selected channel
does not support emergency.
60
English
3 Hold the microphone vertically 1 to 2 inches (2.0 to 2.5 cm)
from your mouth.
4 Press and hold the PTT button. Speak clearly into the
microphone.
5 Release the PTT to end the transmission.
6 Press and hold the preprogrammed Emergency button until
a tone sounds to exit Emergency mode.
Sending an Emergency Alarm with Emergency
Call
This feature gives your radio priority access on a channel for
conventional system, and to a talkgroup for trunking system.
If the radio has both emergency call and alarm features
enabled, it automatically proceeds to the call mode after the
alarm is acknowledged.
Procedure:
1 Press the preprogrammed Emergency button to activate
the emergency call/alarm feature.
2 The display alternates Emergency and the home display.
Advertisement
Table of Contents
