Table of Contents
Advertisement
Turning On the Radio
Press the Power Button briefly
turn on the radio.
After a short time, the red,
yellow and green LEDs light up.
The display then shows Zone
and channel text, and menu
items display on the screen.
The backlight will turn on to the
last selected dim level.
Note:
Pressing the Power Button before the LED lights up
will be ignored.
If Fail ##/## appears in the display, the radio will not
function until the condition has been corrected.
If Error ##/## appears, some non-critical data has
been changed. If either of these displays appear, if the
display goes blank, or if the unit appears to be locked
up, see Helpful Tips on page 113 for more information.
If the power-up test is unsuccessful, you see Error
XX/YY (XX/YY is an alphanumeric code).
Turn off the radio, check the battery, and turn the radio
back on. If the radio fails the power-up test again,
record the Error XX/YY code and contact your dealer.
4
English
Power Button
If your radio does not power up, contact your dealer.
To turn off the radio, press the Power Button after the LEDs
light up.
LEDs
The radio validates and updates the software and hardware of
your control head(s) during power up. Follow the procedure
below when your radio runs this task.
Procedure:
1
2
3
If CH Mismatch appears, means that either the Control
Head has been connected to an incompatible
transceiver, or vice versa.
Validating Compatibility During Power Up
The display shows Maintenance mode remote device;
promptly followed by other maintenance statuses.
The display shows Update done please reset upon
completion.
OR
The display shows Update failed please reset when it
fails to update.
Press the Power Button to reset. The radio runs the usual
power up operation if the software updates are complete.
OR
The radio runs the Maintenance Mode if the updates are not
complete and repeat step 1.
Advertisement
Table of Contents
