Table of Contents
Advertisement
the radio is currently in Direct mode (during conventional
operation only).
You can repeat step 2 to toggle between the two modes. Once
in Direct Mode, press PTT button to start conversation with the
radios nearby.
Monitoring Features
Radio users who switch from analog to digital radios often
assume that the lack of static on a digital channel is an
indication that the radio is not working properly. This is not the
case.
Digital technology quiets the transmission by removing the
"noise" from the signal and allowing only the clear voice or data
information to be heard.
Monitor a channel to ensure the channel is clear before
transmitting.
Monitoring a Channel
Procedure:
Lift the microphone off hook.
Conventional Modes Only:
1
Listen for activity on that channel.
38
English
2
Adjust the volume by rotating the MFK if necessary.
3
If you hear no activity, press and hold the PTT button to start
your conversation.
OR
Trunked Modes Only:
1
Press the PTT button.
2
If you hear two, short, high-pitched tones, or if you hear no
t
tone and the
indicator lights steadily, then proceed with
your message.
3
Release the PTT button to receive (listen).
If you are not in the range of the system, you may hear a
continuous low-pitched tone and the display shows
range
.
Out of
Advertisement
Table of Contents
