♦
Connect the Switch to a 100Mbps server or end-station
An ST (or SC) connector provides the link to the multi-mode fiber cabling and two indicators show the status of the Module
at-a glance. A DIP-switch sets the operating mode to half duplex or full duplex (default).
The following Table 2-2. lists the ports' operating modes based on the DIP switch position.
SW
ON
OFF
Table 2-2. Two ports 100Base-FX Fiber Module DIP switch functions
(1) Two ports 100Base-FX Fiber Module Features
♦
Conforms to IEEE 802.3u Fast Eth e
♦
Support for SC or ST fiber connec t
♦
Supports half and full duplex mod e
♦
Store-and-forward switch architec t
♦
2 switching 100Mbps Fiber Ethern e
♦
Backplane up to 2.4Gbps
♦
Automatic address learning with 1 2
♦
Filtering and forwarding rate of 14 8
♦
100Base-FX uses 62.5/125 micron
DIP Switch Location
Port 1
Port 2
Figure 2-6. Dip switch location and mode settings
PORT 1
1
Half-Duplex
Full-Duplex
rnet standard
o rs (optional)
s via DIP switches
u re for abnormal packet filtering
t ports
K address entry storage
,800 packets per second
m ulti-mode fiber
PORT 2
2
Half-Duplex
Full-Duplex