8 ports 10/100Base-TX Module –
When installed into a Ethernet Switch, the 10/100Base-TX Module provides 8 10/100Mbps Switch ports which
can connect the Switch to a 10Mbps or 100Mbps hub or end station.
(1). 8 Ports 10/100Base-Tx Module Features
♦
8 10/100Base-TX N-Way Switch ports.
♦
Conforms to IEEE 802.3 10Base-T and IEEE 802.3u 100Base-TX and IEEE 802.3x standards
♦
Store and forward switch architecture for abnormal packet filtering
♦
Support for half and full duplex on all ports
♦
Backplane up to 2.4Gbps
♦
2M memory Buffer support
♦
Automatic address learning with 12K address entry storage
♦
Filtering and forwarding rate of 14,880~148,800 packets per second
(2). DIP Switch with Link Mode
The 8 port 10/100Base-TX module provides dip switch for 1 to 4 port to adjust link mode with other network devices.
Another 4 ports use auto-negotiation protocol only. There are three type of link mode can be chosen, Auto-negotiation,
100Mbps/Full duplex and 10Mbps/Full duplex.
If you adjust to auto-negotiation, then the DIP for 100Mbps and 10Mbps is not effective. If you adjust to Full duplex, then the
DIP for 100Mbps and 10Mbps is effective.
The following Table 2-1. lists the ports' operating modes based on the DIP switch position.
PORT 1
SW
1
2
ON
Full
10M
OFF
Auto
100M
Table 2-1. 8 Ports 10/100Base-TX Module DIP switch functions
Two ports 100Base-FX Fiber Module –
When installed into a Ethernet Switch, this Module provides a 100Mbps Fast Ethernet fiber port which can be used to:
♦
Connect the Switch to the backbone of your network; that is, to a basement switch, hub or router
FGSW-8TP
Port 1
Port 2
adjustable
ports
DIP Switch for
Port 3
Port 1 to Port 4
Port 4
Port 5
Port 6
Port 7
Port 8
Figure 2-4. Dip switch location and mode settings
PORT 2
PORT3
3
4
5
6
Full
10M
Full
10M
Auto
100M
Auto
100M
Figure 2-5. 2 port 100Base-FX Module Front View
FGSW-2ST/2SC
ON
Port 1
Port 3
1
2
3
4
Port 2
OFF
Full Duplex
Auto-
1
2
negotiation
PORT4
7
8
Full
10M
Auto
100M
5
6
7
8
Port 4
10M
100M