Table of Contents
Advertisement
Connecting the Ethernet Line
Plug the Ethernet cable into the Ethernet Connection RJ45 port on the back of the
SNE2020G. Verify the connection: solid illumination of the Ethernet Connection Lnk
LED on the front of the SNE2020G indicates a link has been established, if an SHDSL
connection has already been made. If an SHDSL connection has not yet been made,
the Ethernet link will remain disabled (as indicated by solid illumination of the Ethernet
Rx, Tx and Lnk LEDs) until at least one of the two SHDSL links has been established.
Table 4. Ethernet Connection
Pin
Connection
1
Rx+
2
Rx-
3
Tx+
4
not used
5
not used
6
Tx-
7
not used
8
not used
The SNE2020G connects to a PC using a straight-through Ethernet cable and to a hub
or a switch using a crossover Ethernet cable. For any other type of connection, the
circuit presented by the Ethernet device you are connecting to determines the type of
cable you need.
Ferrite Chokes
If ferrite chokes are included with your network extender, install them on all DC power
and signal cables. Position the ferrite chokes as close as possible to the body of the
SNE2020G.
8
Advertisement
Table of Contents
