2.3.3
Install drives
Remove a drive tray. Then install a HDD.
To install SAS drives: align the edge of the SAS drive to the back end of tray; the
backplane can directly connect to SAS drives.
To install SATA II drives with QSATA boards: align the QSATA board edge to the back end
of tray; the backplane can connect SATA II drives through QSATA boards.
Figure 2.3.3.1 SAS drives
LCD display.
Power LED:
Blue
Power on.
Off
Power off.
Access LED:
Orange
Host is accessing.
Off
Host is no access.
Status LED:
Red
System is failure.
Off
System is good.
Mute button.
Up button.
Down button.
Enter button.
ESC button.
21
Figure 2.3.3.2 SATA drives