Cleaning And Maintenance; Safety Advice - Bartscher Aurora 22 Instruction Manual

5. Open the cover thermo pump jug and remove the pump's tube. Open the cover at the
side and place the open thermo pump jug on the lower plate (5) in such a manner that
the thermo pump jug opening is located below the drip opening on the filter basket.
6. Turn the unit on via the main ON/OFF switch (1). The green control light (brewing
indicator) (8) will turn on.
7. Coffee will begin to brew. After a moment hot coffee will pour our into the thermo
pump jug.
8. When the brewing process finishes, the machine automatically turns itself off and the
green control light (8) goes out and an audio signal is heard. The coffee is ready to be
served.
9. Remove the thermo pump jug (6) from the
lower plate (5), replace the pump's tube
and close the cover.
WARNING! Danger of burns!
During the brewing process a small amount of
hot steam is produced. Carefully remove the
thermos from the lower plate to avoid burns!
10. To pour coffee from the thermo pump jug,
raise the arm on the cover up until it
catches, then depress (diagram at right).
In this way the pumping mechanism is
activated. Hold the arm down until the
desired amount of coffee has been poured.

6. Cleaning and maintenance

6.1 Safety advice

o Before beginning with repair or cleaning works make sure the device has been
disconnected from power socket (pull the power plug!!!) and has cooled down.
o Do not use any acid agents and make sure no water ingresses the device.
o To protect yourself from electric shock, never immerse the device, its cables and
the plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets. Therefore, you must not
use any kind of pressure water jet for cleaning the device!
- 30 -