Installation And Connection; Operating - Bartscher Aurora 22 Instruction Manual

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of
the device and is not heat sensitive.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.

5.3 Operating

Prior to first use
•
Prior to first use, run 2 to 3 portions of water without coffee through the coffee
machine in order to rinse the device („Preparation of coffee", steps 1-8).
•
After first use (depending on the construction of the system), a small amount of water
will always remain in the reservoir. Keep this in mind when pouring water again later.
•
Always fill the water container with an
amount of water equal to the capacity
of the thermo pump jug included with
the coffee machine. The amount of
coffee brewed will be the same as the
amount of water poured.
•
If too much water is poured into the
water container, excess water will
drain out through the flow hose.
•
Prior to use, rinse the thermo pump jug and filter basket with warm water and a mild
cleaning agent, then rinse with clean water and dry thoroughly.
- 28 -
Flow hose