Adjustment The Maintenance Mode; Adjusting The Leading Edge Registration Of Image Printing - Olivetti d-Copia 18MF Service Manual

1-6-17 Adjustment the maintenance mode

(1) Adjusting the leading edge registration of image printing

Make the following adjustment if there is a regular error between the leading edges of the copy image and original.
U066
U034
(P. 1-6-46)
Caution:
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
Procedure
Enter maintenance mode.
up/down cursor keys.
Select the items to be adjusted
using up/down cursor keys.
Lead Edge Adj1: Leading edge
registration from the drawer
Lead Edge MPT: Leading edge
registration from the MP tray
Press the system menu/counter key.
to output a test pattern.
(Printing cannot be stopped until the
preset number of sheets is printed.)
Press the back key to exit
Y104230-6
U071
(P. 1-6-50)
Start
Enter 034 using
Press the enter key.
Press the start key
Is the leading edge
registration correct?
Yes
maintenance mode.
End
Leading edge registration
Correct image
*After adjusting the MP tray,
adjust the drawer.
Press the enter key.
The new setting is stored
Press the system menu/counter key.
For copy example 1, decrease
No
the value using the left cursor key.
For copy example 2, increase
the value using the right cursor key.
Setting range
Drawer: 430 to 570
MP tray: –70 to +70
Changing the value by 1 moves the
leading edge by 0.254 mm.
Sevice Manual
(10 mm)
Copy Copy
example 1 example 2
Figure 1-6-52
1-6-41