Table of Contents
Advertisement
Step 3:
To hang the Industrial Media Converter on the
DIN-rail track or wall, please refer to the Mounting
Installation section.
Step 4:
Power on the Industrial Media Converter. Please
refer to the Wiring the Power Inputs section for
power input. The power LED on the Industrial Media
Converter will light up. Please refer to the
Indicators section for the meaning of LED lights.
Step 5:
Prepare the twisted-pair, straight-through Category 5
cable for Ethernet connection.
Step 6:
Insert one side of Cat.5 cables into the Industrial
Media Converter Ethernet port (RJ45 port) and the
other side into the Ethernet port (RJ45 port) of a
network devices, for example, switch, PC or server.
The UTP port (RJ45) LED on the Industrial Media
Converter will light up when the cable is connected
with the network device. Please refer to the LED
Indicators section for the definitions of LEDs.
Be sure the connected network devices support
MDI/MDI-X. If it does not support them, use the
crossover category 5 cable.
Note
Step 7:
Insert the fiber cable from the IFT-802T / 802TS15
/ 805AT to the fiber network. TX and RX must be
paired at both ends. The optical port LED on the
Industrial Media Converter will light up when the
cable is connected with the network device. Please
refer to the LED Indicators section for the definitions
of LEDs
Step 8:
When all the connections are all set and LED lights all
show normal, the installation is completed.
LED
21
Advertisement
Table of Contents
